Purpose

The primary purpose of this holder is to organize and hold K Cup coffee pods efficiently, making them easily accessible while adding a stylish element to your kitchen or office.

Design
The minimal design with the cross supports were made to give some personality to the print while also keeping it sturdy. The cross supports were initally made to help print better (which did not help much) but added a bit of character so they were kept.

Printing Suggestions

Use PLA or PETG for a sturdy build. Supports are necessary for the print setting in most orientations for quality. A layer height of 0.2mm or 0.24mm is recommended with as low as 10% infill.

Assembly Instructions

The holder is printed in two parts which can be easily assembled by clicking together together.

Side Note
Model files are provided in STEP for better curve quality on bottom piece although STLs are provided.