Summary

https://www.cncdrones.com/SAF-10_p_1154.html

Based this off of FR10 frame, tightened the props in closer to the frame but this will require higher gopro tilt if you dont want them in view, 30degrees gets reelsteady'd out

• CF Parts

-Thin version

2 - 10frontarm in 8mm
2 - 10reararm in 8mm
1 - 10topplate in 3mm (0.5mm chamfer outside/battery strap slots on both sides)
1 - 10bottomplate in 3mm (7x m4 pressnuts)
1 - 10armplate in 3mm

-Thick version

2 - 10frontarm in 10mm
2 - 10reararm in 10mm
1 - 10topplate in 3mm (0.5mm chamfer outside/battery strap slots on both sides)
1 - 10bottomplate in 4mm (7x m4 pressnuts)
1 - 10armplate in 4mm

• Hardware

-Thin

7 - m4x16mm for arms
8 - m3x20mm for arms into standoff /FC mounting
20 - m3x8mm top/bottomplate into standoffs
16 - m3x12mm for motors
12 - m3x20mm standoff

-Thick

7 - m4x20mm for arms
4 - m3x25mm for arms into standoff
4 - m3x20mm for FC
20 - m3x10mm top/bottomplate into standoffs
16 - m3x16mm for motors (with 2 washers per bolt)
12 - m3x20mm standoff

• 3d prints

4 - Arm Protection by Siclair https://www.thingiverse.com/thing:5785402
1 - Hero 8 mount by Siclair https://www.thingiverse.com/thing:5772335
1 - Hero10 mount
2 - fpvcam mount (one mirrored)
1 - reardualantennamount10 or o3antennamount
1 - capholder
1 - M9NGPSholderlong