Monkey Butler Ring Holder - Split File w/Supports *NEW BASE
ShinyFender07
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2018-09-16 04:34:18
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
Summary
My Da Vinci 1.0A printer had a hard time with any supports going all the way to the arm and tray. I split the tray and arm to print separate. I was able to save 3-4hrs of printing this way. I used a cheap 2-part epoxy to glue the tray to the hand and the arm to the body. Came out nice. Made 14 prints for family. I purchased Tungsten rings for them as a gift.
*I added a new base.
Print Settings
Printer:
Da Vinci 1.0A E3D V6 Clone
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Notes:
Da Vinci 1.0A - repetier 0.92, E3D V6 clone with bowden setup. 1.75 PLA @ 200 Degrees. 6" blue tape on removable glass with purple blue. 30 speed across the board. 0.2mm resolution.
*I used meshmixer to add 0.2mm supports to the body and arm.
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY