This is a mount for a camera using a standard mounting screw (1/4-20) that attaches to the top corner of the front 2040 extrusion of the Bear frame. It's designed to put the camera either on the front-left or front-right corner at a reasonable height to get a good view of the printing in progress.

It's working great with my Logitech C920S. To screw it down, I used a 1/4 in.-20 x 1 in. brass knurled screw.

Print instructions

• Prusament PETG
• Layer height: 0.20mm
• Infill: 15% (gyroid, but any should work)
• Supports: Yes