I am lazy and I did not want to have to buy new screws, so I designed this handle for the MPSMv2. It might fit a V1? I'm not sure.

Uses 3 of the stocks screws which hold the metal frame together.

You can print without supports, or add a couple to the very back of the handle curve.

(Pictured was without supports)

You will have to flex the back metal panel out slightly after the screws are removed (just using the slot on the left and your left hand) in order to hook the hook at the back. After that, the rest should snap on easily, and you can drive the screws back in.

Works a treat! Enjoy!

Category: 3D Printer Accessories