Did a remix on the salt cap that drcyberg created. Ours was completely cracked some how and the prices they ask for a simple cap are a joke :-) Saved me 25 €.

I redesigned it a bit, making it a bit higher so the thread would grab better. Also added the old salt float indicator on my cap. Works like a charm.

This dishwasher is a Pelgrim pelgrim gvw535rvs/p01. Print in ABS else it will melt in your dishwasher :-)

Used 0.3 layer, 100 % infill. You can use supports for the rims/edges.

Update 15-10-2018

I noticed that it was a very tight fit and that the gap at the Cap off the Pelgrim needs 5 mm at the lowest part. Added that version V2.

Anet A6

No

Yes

0.3

100%