Scootaloo, just walking around.
(My Little Pony fanart.)

Based on the drawing by xbi: https://www.deviantart.com/xbi/art/Everfree-Forest-Cmc-Scootaloo-Sweetie-Belle-Apple-828884645

Print instructions

The model comes in two variants: one with hair, one one without.
If you print the one without hair, you can for example glue on yarn as hair.

I have not tested the version without hair!

IMPORTANT
The center of gravity of this model is very close to the left side of the front leg.
Depending on your slicer settings, your finished print might not be able to stand!
To ensure that your print can stand:

• print the tail with higher infill (this is already done in the gcode and 3mf), and
• ensure good bed adhesion, so the hooves end up flat. (I did not have an issue with this, though.)

The version without mane and tail may not be able to stand at all.
However, you can glue it down or add a base if you want to.