Summary

This print-in-place hinged Raspberry Pi case is a remix of 0110-M-P's design.

I made this because I really liked his design but I needed better access to the GPIO pins than the pop-out pieces provided in the origional model.
This design adds a print-in-place hinge that flips out to give easy access to the GPIO pins.

This is for any of the Raspberry Pi Model B+s and the Raspberry Pi 2

I have also included the origional bottom file of the Raspberry Pi case.

To reduce elephant feet fusing the print-in-place hinge on the bottom layer, try setting the "Initial Layer Horizontal expansion" to -0.5mm or so in your slicer.

Make sure to print WITHOUT supports!