Camera mount for the Eufy 2K Indoor camera. For mounting the camera in the top, front, right corner of a Ikea Platsa enclosure. This will put the camera in a position that allows you to view the entire enclosure.

Easy to print, doesn't require any supports. 

To install the camera, the swivel mount of the Eufy camera needs to be removed. This can be done without any damage to the camera, but requires a bit of finesse.

• On the bottom of the camera, there is a small gap. Insert a plastic tool and move the tool up and down to separate the back of the camera a little.
   

• Move the plastic tool around the edge of the gap until the backing is free.
   

• Carefully remove the camera and electronics from the back (there are some wires still connecting the front to the back)
   

• The swivel mount is connected with a single, small screw. Remove it and remove the swivel mount.
   

• Re-insert the front into the back part 
   

• Done.

Note that in order to install the mount in the highest possible spot, insert the camera into the mount before installing.