A basic riser for the Kobra S1 lid. As is, the riser lifts the lid 20mm, to prevent the PTFE tube from scratching up the lid. If you need/want more height, you can adjust the Z height as needed.

The Front and Back sections are taller than the sides due to the way the S1 is put together - if you increase the Z height, add 1mm to the front and back to account for this.

I printed in PETG as they will be exposed to the heat from the print enclosure - I would suggest you do the same.

You will need to print:

2x Lid Riser Back Corner

2x Lid Riser Front Corner

2x Lid Riser Sides

1x Lid Riser Front

1x Lid Riserd Back