Inspired by an organizer made from wood in Woodsmith Shop tips, I designed this to print as it will be faster to print these and I was able to make this smaller than the equivalent wood part because I could make it thinner. Printed in ABS; the pockets are slightly over-size to account for ABS shrinkage. If you use other material, you may have a bit of extra room -- Epoxy should fill the gap.

Airwolf Axiom

No

No

0.3 mm layer height

30%

You will also need:
1/2" neodymium magnets - Qty 2
3/4" neodymium magnet - Qty 1
Epoxy

Print the tool holder, clean out the magnet pockets of any extraneous filament, epoxy the neodymium magnets into the pockets, let epoxy cure