I was browsing TikTok and saw a tattoo of a "Gary-Ados" and it prompted me to go looking for a printable model and to my absolute surprise it hadn't been done so I decided to make it! Thanks to DreamSpace and NerfherderDave for the models, I just joined them in Fusion after a bit of mesh editing.

Yes

Yes

0.1-0.2

10-20%

A raft or brim is required to print this model because the tons of supports need something to bond to. On FDM the model needs to be printed at a minimum 90% with a 0.4mm nozzle otherwise the tail fin won't print.