Summary

Filter and heater system for Elegoo Mars/pro 2. Designed to be printed with FDM.

The heater is from here: https://www.thingiverse.com/thing:3412516
Specifically this version: Mag_Heater_v22.stl

Air filter is inspired by this one: https://www.thingiverse.com/thing:2394452
Unfortunately that design is too bulky to fit inside the Mars 2. My design is minimal and much easier to print. See the original design for fan/filter specs.

The extender (for cable management) is a slimmed down version of this design: https://www.thingiverse.com/thing:3961433.
The extender is a tight friction fit. It may take some tuning with a utility knife to remove possible elephant's foot.

Instructions:

1. Super-glue filterCover to filterBody.
2. Super-glue the heater to heaterMount.
3. Super-glue the filterMount to the heaterMount.
4. Assemble filter (1/8x1/2 bolts)