Wire Twister - Twisted tool (looking for input, want to make this a really good tool for everyone, cause twisting wire sucks)

Pretty easy too use, print it off (do yourself a favor use a tough plastic PLA can work but any load can fracture it) Chuck it up.

Strip your wire back about 1/2" put leads in the holes around the outside hold the wires with needle nose or linesmen's, and turn on drill. Take it easy on the trigger until you get the hang of it.

If you want a straight single strand in the middle strip 1 wire out 1" or so and insert in the middle.

Takes a little playing insert the insulation in a hair. Enjoy. This is the prototype let me know if you have any good ideas to add to it.

fusion

No

No

.20

80-100%