I found that I needed a support rack for my Soda Stream bottles. I refill the bottles using Dry Ice and since I could not get a block of it under about 7 lbs., we purchased additional bottles (so we weren’t throwing away as much left-over Dry Ice). The problem was that I could not find any racks that were configurable to hold more than a couple of bottles. So, I designed a modular rack that could be used for a different number of bottles. You could use just the top and bottom for a two-bottle rack or you could use as many of the middle sections that you might need. For our use I made a five-bottle rack. For each rack space you need a front, back and a support piece. You will also need Pins to hold the front and rear sections together. I use 4d finishing nails cut to 3/8”. I have included an assembly diagram to show how the components go together. Assemble the front section and rear sections together first (by pinning them) then insert the support pieces.

Creality CR-6 SE

No

No

1.2

50%