Summary

The fireTV remote controller has a rounded bottom so you can't operate it while it's on a table.
It is an additional part to solve this problem.

After printing, attach it to the back of the remote controller with double-sided tape.

[caution]
Only stick the double-sided tape on the lid of the remote controller. If you put double-sided tape on the entire surface, the lid will not open.

[print conditions]
-printing type: FDM
-printer: Original Prusa i3 MKS
-filament: PLA
-support: no
-brim: no
-raft: doesn't matter
-infill: 15%
-nozzle diameter: 0.4mm
-layer height: 0.2mm
-print directions: Please refer to the photo.