Bills Mafia tailgate table...

To make the table, print one tabletop and two copies of the legs. The legs should snap into the tabletop without much trouble. If they're tight, try cleaning up the holes with a needle file. You don't want them too loose though, so I recommend just snapping them in and working them back and forth a bit.

I think it looks especially good if you print the tabletop in white and the legs in gray, black or silver.

There is a ring at the end because I'm using it as a Christmas ornament, but it can easily be removed with an Xacto knife.

AdimLab

No

Yes

20%