This case fits all of your drawing essentials into one pack for when you want to get artsy on the go. Need a little escape from the busy work day? No problem, allow yourself to unleash a little creativity.

Printing:

1. Print the two outer pieces and the bolt in normal PLA or other hard material.
2. Print the two inner pieces in Ninjaflex or other soft material. These have to be printed in a soft material because of the overhangs that hold the pencils in on the top piece. You would not be able to get pencils in or out if they were hard.

Assembly:

1. Put the inner pieces in their respective outer pieces (they should not need glue to stay in, but you can put some in if you really want to).
2. Put your drawing essentials in the slots and compartments (you can use my setup as a guide, but it doesn't have to be exactly the same).
3. Put the top and bottom pieces together, with the rod on the top piece going through the non-threaded hole on the bottom piece.
4. Put the bolt in from the top and tighten until it feels secure.