I almost forgot to put these on ere....

simple direct fitment corner mounts with level adustment.

no cutting, no drilling no trimming, just print 4, slot on each corner and screw heated bed down on springs, nice and solid with zero faffing about with hacksaw blades and drills and no need to damage the original print bed.

works with mk2,mk2b & mk3alu reprap heated bed (tested).

requirements -
4x m2x20mm screws/bolts
4x springs (specfic heated bed springs from eGay or even 4 from some cheapo clicker biros will do the job)

print from either PLA or ABS (whichevers your poison), Ive not had heat propergating down the screws or springs at anywhere near enough to effect the parts and thats even with the Mk3 Alu heated bed running at 120°c

enjoy.

colido printrite diy ramps1.4

No

No

.3

30%