Summary

I liked and tried browns controller stand and looked at the remixed wall mount as im hoping to clean up the space all my collections controllers take without hiding them away, however the two mentioned above dont work with a Xbox 360 controller as well as not fitting my Sega wireless controllers well.

I have alot of controllers so went with the 4 stack like browns as i figure a lot of users interested in something like this will either have two of each system or a full set for each system.

I decided to just incorporate a wall mounting solution in from the start but also make a base that attaches or can be attached directly to the model for printing with it that way should i decide to take them off the wall and place them on a stand it wouldn't require fully reprinting rather just printing the base

browns also uses alot of hard block edges and seems to use more material then required so i tried to make mine more of a frame work design- granted the controller upper stop/ cross brace on mine could likely be reduced but i liked the look more then browns.

works with most controllers including 360 with the text pad attached.