WARNING: this print will sit very close to hot electronics. I strongly recommend printing in a filament that is not a fire hazard, OR using very low temperature bulbs (in my case, I use 1.5 watt LED's)

I created a custom lamp mount (for some cheap brand-unknown lamp) and utilized the shade from jpnurro's remix of a geometric vase - and thetazzbot's bowl for a different shade.

On the offchance you have a lamp with an identical screw mount

The mount ring is original.

Original:
https://www.thingiverse.com/thing:3222883
https://www.thingiverse.com/thing:3870852

Prusa

I3 MK3S

No

No

3

0 top/bottom layers on the lamp, 0% infill, 2 perimeters. NOT printed in spiral vase mode, due to wanting a fused shade and mount, but works fine. 20% infill on the ring mount

Brim 3mm on both lampshades.

Wider shade printed with a 43mm hole in the middle (with modifiers) to fit its 42mm mount.