This computer case foot (CF2-AP280) was designed as an alternative to replace the (short) factory foot, for the Antec P280 computer case, since the case was sinking too far into carpet and chocking off the air supply to the PSU (power supply).

MakerBot

MakerBot Replicator 2X

No

No

Any

Any

SUGGESTED ITEM PRINT SETTINGS

No Raft - No Supports - Any Infill % - 3 Shells Recommended (if not printed with 100% Infill)

PLEASE NOTE:

1. STL file was saved in the suggested printing orientation, in order to avoid the use of supports.
2. Part has been designed for ABS filament, PLA will have different tolerance at 100% scale.
3. Center hole was designed for M5 screw (or #10-24UNF or #10-32UNC).
4. Minimum recommended screw length: 11mm or 0.5 inches.
5. Center hole has 0.3 degree draft/taper to accommodate easier insertion of screw.
6. M5 or #10 tap can be used for ease of tapping threads, however screw can be threaded in by hand-tool without thread tap.
7. Circular recess (on bottom of foot) accommodates silicon-rubber pad found on factory Antec P280 foot, which is reusable.