Summary

I originally made this for a project for the girls in my troop for a Christmas party, but I thought this would be a good time to upload this for the contest. Brief warning: the holes the pegs fit in are a little tight, and when you do wedge them in, the pegs will be sticking out, so you may have to clip them. I also made the sticks on the kit cards fairly thick so they could easily be removed without easily tearing up. (sorry, this is my first kit card!!!) Otherwise, I hope you enjoy my project!!! ❤️❤️❤️

UPDATE! According to carlisthebest, sanding helps the pegs fit in the holes! (Thank you!!!)

How I made it
This project took a long time, I estimate around 20ish hours went into perfecting the design in TinkerCAD. Most of the time was put into perfecting the holes so the pegs would fit in, although it is still a tight fit. Printing also took a while because I had to make it in batches so everyone in my troop could make an ornament, so 48 kits took about 36 hours to print in batches of 12.

Supports
no

Rafts
no

Layer thickness
.2mm

Printer I used
Bambu P1S

Material I used
PLA