A few months into 3D printer ownership and I find that not all spools are created equally. Case in point, the mounts that come with my FFCP (2016) are too shallow to hold a specific brand of filament I purchased online.

I couldn't find a solution that exactly fit my needs, so I created one!

This spool holder is meant to hang off the back of the printer, just like the original setup, except these are larger and allow spools up to 75mm wide! The tab on back that is inserted into the case is 49mm wide. The max diameter of the post is 49mm and the end cap has a total diameter of 53mm. With the sloped tip, threading a spool onto the holder should be simple. Theoretically this holder should also work with other FFCP/Replicator clones.

This is intended to be printed without support (pesky stuff)

FlashForge Creator Pro

Doesn't Matter

No

0.2mm

25%