Eccentric Knee Connector for Umbrella

A functional replacement connector designed for umbrella assembly. The eccentric joint allows the connected part to be positioned and adjusted to the required angle.

The part is designed as a simple, strong and lightweight 3D-printable component and can be used as a replacement for a damaged or worn original connector.

Print recommendations:

• Material: PETG recommended
• Layer height: 0.20 mm
• Nozzle: 0.4 mm
• Walls: 3–4
• Infill: 15–25% Gyroid
• Supports: recommended for the overhanging area
• Print orientation: as provided in the print profile
• The part shown in the photos was printed in Bambu Lab PETG.
• Note:
  This model is intended as a replacement/functional 3D-printed part. Depending on the umbrella design and load, dimensional adjustments may be required for a proper fit.