I finally received my Steam controller and needed a Dock to present it on my desk :).

No supports necessary!

I printed it in PLA on my Centauri carbon at 0.2mm layer height and 20% gyroid on the bottom part and 5% on the upper part to make it bottomheavy.

After printing insert the puck with the usb c female first and slide the bottom in and plug the cable through the holder. (This is intended to hold the puck in place).

Please give me feedback and/or post pictures of your makes :).

I am still very new to 3d modeling and this is the first model I made in blender.

Printing takes ~2hours depending on infill/wallcount.