Insta360 x3 Loop Mount
module_valley
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-01-15 09:16:23
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
- Sliced with CURA.
- Print with 100% infill.
- Print with support at 36 degrees. Screw may need some light cleanup, but screwing it in the camera should re-tap it.
- Recommended to print with a brim.
-
Takes about 30mins to print with my slow settings.
- Not tested with PLA, but should work fine.
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY