I needed a longer and skinnier screw to be able to open the battery door on my hero 10 camera.  The factory screw was too wide in the handle and wouldn't allow the door to drop down and it was a pain to remove the screw since it was hard to grip.  The design utilizes a M5-.8x40mm hex head screw (bolt) that slides into the print.  There is no need for glue as the design should hold the bolt captive and it shouldn't back out without a large axial force.  The design is scaled for a Prusa Mk3s+ and Bambu x1c in PLA.  If you are using a different printer or material you may need to change the scale in your slicer.  I added extra wall loops to my prints to ensure it was printed solid and have had no issues.