Original blade holder got weak and is not capable of holding the blade anymore?
I made a new one just for ya :D
It holds the blade tight while still providing a good and easy spin.

- 0.08-0.12 layer height
- 1 wall
- 100% concentric infill
- No brim
- No supports
- 5m, 0.4g
Also don't use soft filament. I'm not sure if PETG will hold because it is relatively soft and might destroy itself after the first couple of blade swaps. PLA should be good enough.


User manual:
1. Pull the old malfunctioning thingy out with tweezers or wire cutters.

2. Push the printed one in. The side doesn't matter, it's symmetrical.

3. Push the button, push the blade in, use some finger force if needed, it might and should be tight.

4. Go deburr :D