Got tired of my chap sticks falling over so I made this to keep them upright. The holes are about 1mm wider than the Burt's Bees chap sticks I use so they fit snug but are easy to remove/insert. Printed with PLA.

I printed on Ender 3 S1, using Cura.

Here are the settings I used to print in 1 hour:
-Layer Height: 0.3mm
-Infill: 20%
-Infill Speed: 100mm/s
-Print Speed: 70mm/s
-Use a Brim, with 12 lines, inside & outside
-Other settings set to default for PLA.

STL, STEP, & Fusion360 file are available.