THIS IS AN ADD-ON for another user's model found here: makerworld.com/en/models/16294-compact-fitting-socket-for-dry-box

This is a hygrometer holder for mounting sensors inside your dryboxes using the model above. It gets twisted into place behind the inlet adapter adapter piece as shown in the images.

Step 1: Insert hygrometer into the frame. I used these: https://www.amazon.com/dp/B07MCGDN5C?ref=ppx_yo2ov_dt_b_fed_asin_title

Step 2: Insert nuts into their slots before attempting to install the clip.

Step 3: Slide clip vertically over the inlet side. It will hold the nuts in place making installation easier.

Step 4: Rotate 90 degrees to snap into place.

Step 5: Screw the socket pieces into place as instructed on the model creator's page

Printed in Bambu PLA with standard 0.20 settings