A nice sturdy 100% 3D printed place to hold some of your filament

I created this project when my filament started rolling everywhere all over the floor. Somehow in the doorway? I started searching for a good filament spool holder. All of them had a wooden pole supporting the filament. I wanted a 100% 3D printed filament holder, so I decided to design one myself

all of this would not be possible without https://www.tinkercad.com/ (tinkercad)

side support:

hold the poles together

center pole support:

prevents the pole from bending to the ground

pole ends:

the endcaps of the poles that create a flat ends

center pole:

can be linked together to create longer or shorter poles

(you can use super glue)

supports: only "Center pole.stl"

nozzle: 0.2mm

Infill: 50%

Infill pattern: lines

Filament: Blue Sunlu PLA

most of these settings vary depending on your printer

I have no Idea if it works on resin printers too, but it is open for testing