I have my two Snapmaker U1 printers on a very low table.  I could not read or use the screens as they were shipped because of the angle.   I tried every mod that I could find and none worked as well as I wanted.  I took two and combined them.   The Snapmaker U1 Touchscreen Tilt Mount was the closest to what I wanted, and printed the 30 and 40 degree model.   The 40 was the best for my needs.  It had two problems for me, the need for supports and the way it attached.  One of the other mods I installed used a high quality double sided tape and it held very well.   This mod prints with no supports and is held in place with double sided tape.

I applied the tape  to the printed mount, then used a scalpel to trim the edges flush.  Be careful, of the blade and to not pull the tape off of the mount.

I purchased the following to allow much easier installation  this will extend the flat cable by 20 cm.

Refer to https://makerworld.com/en/models/2521900-snapmaker-u1-angled-hinge?from=search#profileId-2774511  for instructions

I ordered them from AliExpress - see the screen shots for the exact specifications.

32-pin 0.5 mm pitch 20 cm FPC cable

Make sure you get type A - the contacts need to be on the same side.

https://www.aliexpress.us/item/3256807344703492.html?spm=a2g0o.order_list.order_list_main.5.40f51802HzXuyG&gatewayAdapt=glo2usa

32-pin FPC extension board

https://www.aliexpress.us/item/3256805690850934.html?spm=a2g0o.order_list.order_list_main.11.40f51802HzXuyG&gatewayAdapt=glo2usa