Please print it with a 100% fill rate, a layer height of 0.08 mm, and a base layer height of 0.16 mm.

The model size in the print configuration file is 200×200 mm, and you can also download a small STL file with dimensions of 150×150 mm.

Please do not adjust the Z-axis height in the slicing software! Otherwise, the thickness of each layer will not match accurately. You can only modify the dimensions in the X and Y directions. Under the condition of a minimum layer thickness of no less than 0.48 mm, you can also choose a higher layer height for printing; the maximum layer thickness is 2.24 mm, and the actual layer thickness is also 2.24 mm.

Depending on your printer model and firmware support, you can also print without an automatic consumables system by manually switching the consumables in the slicing software

The above are the printing settings and color scheme I used for the artwork in the picture. Your printing results may vary depending on the consumables you choose.

Consumables used:
PLA Anycubic, black. Transmission distance: 0.3
PLA Sunlu Metal Grey, transmission distance: 3.5
PLA Elegoo + Orange, transmission distance: 6
PLA Aurapol Beige, Transmission Distance: 2.4
PLA Elegoo Basic White, transmission distance: 7
A total of 5 different consumables were used for this printing.

Material replacement instructions:
Use black as the initial color
When it reaches the 8th layer
When it reaches the 14th layer
When it reaches the 17th layer
From the 22nd layer