A label for a regal, mounted on a metal girder which holds the board.

On Github: https://github.com/armin-fx-toolix/label-mount

The label is designed for a regal girder with a height of 8 cm.

You have to print 2 parts, a top part and a bottom part.
You can print these without support.
Then you must assemble these 2 parts together.
You don't need any glue, both parts snap in.

You need 4 round magnets with size 10x1 mm.
Glue these on the back side into the holes.

You need a A4 paper.
Fold this paper twice an slide in by the slot in the side.