Walter / Moen WP76918 replacement faucet. Recommend printing in PETG / ABS / Nylon. Print with Supports. Bambu Carbon X1. Recommended PETG settings: reduce feed to 10 MM. Bed temp of 75 Degrees and Nozzle Temperature of 255 to 265. It requires print support. I also suggest print with the handle face point up and not on the bed. It uses a little more material, but the handle is stronger. The fit should be very tight and may require the handle installation with the mounting screw. The valve splines are integrated and extended to prevent slippage. The total Material Used with supports is 10.11 Metres, with 30.89 grams of filament. Print time is approximately 1H 3 minutes. The cost is less than $1.00 vs. $20.00 for the hardware store's replacement price. I didn't have Blue or Red PET G when creating/printing.