This is a mount for the (AK55 70w Bluetooth amplifier)[https://www.amazon.com/dp/B0FG2Q25GD?ref=ppx_yo2ov_dt_b_fed_asin_title]. It was designed so I could mount it vertically, though it could be used in other orientations.

Vertically Facing down

Use faceMount and snapMount. First hold the faceMount in the desired position and mark and pre-drill the holes. Then align the snap mount above it using a straight edge on one side and mark and pre-drill the holes. The faceMount will be tight, force it into position at an angle (front edge touching mounting surface) and snap corners in. The snapMount should attach easily.

Vertically Facing Up

Use rearMount and snapMount. First hold the rearMount in the desired position and mark and pre-drill the holes. Then align the snap mount above it using a straight edge on one side and mark and pre-drill the holes. The rearMount will be tight, force it into position at an angle (back edge touching mounting surface) and snap corners in. The snapMount should attach easily.

Snapmaker

Snapmaker 2 A350

No

Doesn't Matter

.16

At least 25%

Make sure to print the snapMount on it's side