Don't you have a bunch of Benchy models just sitting around collecting dust? You can turn them into a fun toothbrush holder and put Benchy to good use!

It can also hold: pens, pencils, brushes, and more!

Recommended print settings:
Layer height: 0.15mm or finer
 

Assembly instructions:
After printing, the Benchy model can be pushed into the base. The Benchy model should fit very tightly. If it's too loose, please apply some glue to fix it.
 

The tolerance is 0.05mm to ensure a close fit. If the tolerances are too tight or too loose, please feel free to leave a message, and I will add a model with adjusted tolerances.