Rubber foot mats
Guy Hernandez
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-02-08 10:00:25
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
Bu içerik otomatik olarak çevrilmiştir. Orijinali göster
This is a device footpad made of TPU95A, with a hole in the middle for M5 screws.
I suggest using pan head screws.
But this foot mat can also be fixed to anything with instant glue.
I printed these
I used Sunlu TPU95A gray consumables.
I adopted the following parameters:
The general TPU configuration of Bambulab
The temperature has dropped to 205°C.
Set the temperature of the printing plate to 35°C.
Keep the speed at the default setting
The floor height is 0.2mm
The first-floor wall
Fill in 15% of the honeycomb structure
Important notice: Please turn off the auxiliary fan when printing TPU!
This will cause the model to experience severe warping and deformation due to the geometric shape.
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY-SA