This is a Killswitch lock and mount for the Steam deck to mount the sabrient M.2 2230 SSD enclosure. Can be printed in PLA, but I would suggest PETG or ABS due to the heat the enclosure puts off could potentially warp PLA. Plus with the mobility aspect, PETG would hold up better in the long run if you travel a lot with your Steam Deck. You will need super glue (ideally super glue gel or cyanoacrylate) to put the lock and the plate together. According to DBrand there is roughly 0.4 mm tolerance between the lock and plate to account for super glue.