Snap off blade hand wire stripper, square blade.

BE AWARE OF SHARP EDGES OF BLADES, DANGER OF INJURY
WORKING SAFLY WITH SHARP BLADES OR EDGES
I AM NOT RESPONSIBLE IF YOU GET INJURED

Needed part:

-3D printed parts
blade block
hand blade holder
-Snip off blade - small
-Pliers
-Sand paper
-Lighter

1. Print parts as is shown in slicer picture, process edges and sand surfaces of blade blocks so they snap into the blade hand holder.

2. Snip off 4 identical small blades and with the help of pliers sand lateral edges of blades to be in line (without bulge).

3. Insert sharp edges of blades one by one in holes until they enter 1/2 inside blade block, after that press it together (blunt edge) in hard wood or metal to enter completely in blade block. If blades don't want to enter warm up blades with lighter 2-3 seconds and then try to push.

4. Parallel insert assembled blade block into blade holder.

My design use PLA plastic, 0.2mm layer height.

Thank you.