A Suspended Ceiling mount with Clip on Face, for the Supercircuits.com PC504XS Camera.
Rotates 360 degrees, and Can angle down or up.

I needed something to fill a need, and thought I'd share.

This is an inexpensive Day/Night Camera, with BNC Female connection, and Molex Power Connector. Standard 3.5 I believe.

This is a work in progress.
The Base Mounts for the Board Camera that are inside the enclosure don't all match up with the holes. But you really only need one tiny screw to hold in the cameras.

Prints best in Cura 15.04.6 as the enclosure walls are very thin.

But I'm sure someone will be a bit more perfectionist and correct this :-)

Enjoy!

RepRap

Folger Tech Prusa i3 2020 Aluminum

Doesn't Matter

Doesn't Matter

.12mm Layers .4MM nozzle

I use 100%

This unit was printed initially with rounded ends, but did not lay flat on the bed. It seems to print better the way it is now.

I used M3 Hardware, and always leave my holes a bit small and drill out to the size I desire.

Just seems cleaner.

Drawn in 1.5 hours in Sketchup.