Two button controller for the videogame UNBEATABLE

Or any other games that use two buttons.

Printing instructions:

• Print the main body with the grille side facing upwards

• For the grille: Print without top/bottom layers, pick an infill pattern that will look cool when it's shimmering through the fabric later

• Backplate: optional. Sort of.

Assembly:

• Remove enough support material from the main body to make space for the backplate and any of the many commercially available arcade stick guts of your choosing

• Snap buttons into place and connect to the arcade stick board

• Plug in the USB cable and affix the board wherever there's space using gratuitous amounts of hot glue

• Optional: if there's a bright LED on your board, you may want to cover it up if you don't want it to shine through the grille

• Span fabric over the grille, and attach with a slightly less gratuitous amount of hot glue.
  Here it helps if you sort of lay the fabric onto the main body to use it as a jig, then sandwich the speaker grille on top of the fabric. Flip the grille around afterwards and glue into place

• Attach backplate using screws or glue, to taste.

• Add rubber feet to the bottom if you're into that sort of thing

Notes

This controller is, almost by design, an ergonomic nightmare.

UNBEATABLE also occasionally requires, on the higher difficulties, hitting a third input while already holding two buttons down. This isn't gonna work on this controller.

tl;dr: Only print this thing as a fun novelty.