This is a smaller version of Thing 1787860... which I forgot to post until now.

It's not simply scaled-down from Thing 1787860, but has relatively beefier structure while maintaining a good tolerance between surfaces that shouldn't touch. It is a quick print to produce this tiny, but quite strong, pair of pliers. Yes, that is a dime sitting next to it.

The design is a true metamaterial: the entire object is literally one piece, even the hinge and spring, all printed without spans (and hence without supports).

Print Settings

Printer Brand:

MakerGear

Printer:

Rafts:

No

Supports:

Resolution:

0.25mm

Infill:

Notes:

The only thing to watch is that your slicer doesn't mess-up the spring. CURA seems to do fine, but Slic3r has been known to fragment the spring into pieces under some combinations of slicing parameters.