Additional Parts needed

• 1x Bahar Enclosure 150*140*70mm project box
• 1x C-Control Pro Nr. 197220 SD card module
• 1x MeanWell RS-15-5 PSU
• 1x CBM D9069 PetSD+ variant board (https://github.com/InsaneDruid/CBM-D9096/)
• 2x 5mm LED (one red, one red-green two wire bicolor)
• 1x C13 IEC 60320-1 connector ("Kaltgerätebuchse")
• 1x Snap-in-Switch for 13*19mm mounting cutout, rated for mains voltage
• 1x Snap-in-Button for 8mm mounting hole (reset switch)
• 13x M3 threaded inserts for 4*5.7mm mounting hole (Ruthex RX-M3x5.7)
• 12x M3*8 Bolts
• 3x M3*6 Bolts for LED bracket and PSU

Build Info

Set the threaded inserts before clipping the frames onto the front and back plates.

The PSU screws shall never protrude more than 4mm into the power supply housing! 

The inserts for mounting the PCB are inserted from below, but the screws are inserted from above to ensure maximum stability. The same applies for the inserts to secure the C13 connector.

Additional Info / Disclaimer

Wiring the mains voltage should only be done by a certified professional.  The the metal parts of the case have to be earthed correctly! I accept no responsibility for damage caused by improper wiring by non-professionals!