modular wine rack
barbara_costa79
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-03-29 10:12:12
0
0
000Описание
Источник модели
Отзывы(0)
Parameter Suggested Value / Notes
Nozzle size 0.4 mm (designer also uses 0.4 mm)
Printables
Layer height 0.20–0.30 mm (designer suggests 0.30 mm)
Printables
Infill ~ 20% (designer suggests 20%)
Printables
Support Use supports only where needed (on the build plate / under overhangs) — the designer says “Supports: On build plate only, and only under the two tenons.”
Printables
Material PLA, PETG or ABS (designer lists these)
Printables
Print speed / acceleration Adjust based on your printer’s capabilities; start with moderate speeds to avoid ringing or artifacts
Bed adhesion Use a brim, skirt, or adhesion aid (e.g. PEI sheet, glue stick) as needed depending on material
Cooling Enable part cooling for PLA; for PETG / ABS adjust cooling carefully
Orientation Orient the parts so that the tenons / mortises have good support and minimal overhangs
Источник модели
Оригинальная ссылка: Посмотреть детали
CC BY