LED Bridge made for 120cm wide desks. 

There is a total of 22 segments to make the bridge, with one joint to connect the segments on top (segments 11).

There are two diffrent base's, one with space for the electronics and one without. There are hex holes for M10 nuts to use as weight in the base. 
The base cover fits bose base's and are secured with eleven 3.0x15mm screws.

This print is made so it also fits small printbeds.

Print list:

Bridge segments (Print twice) x2
Electronic base x1
None electronic base x1
Base cover (Print twice) x2
Bridge segment 11 joint x1