Small (4" by 4") stackable project bins. Great for holding small parts
while building a project (like a 3D printer) or storing parts for a project
"that will be finished at a later date".

!!!!!!IMPORTANT!!!!!!
Slic3r screws up the corners unless "Printer Settings/Dectect thin
walls" is turned on. The bin really looks like crap if you don't do this.

Use a 100% fill rate (it uses the same amount of filament as 20%), the part
looks better; slicer doesn't add voids in the corners.
!!!!!!!!!!!!!!!!!!!!!!!!!!

0.3mm layer height.

A brim can help if you have problems with corner lifting.

File name: the numbers are the dimensions: 4x4x1.25 is 4" x 4" x 1¼"
deep, the inside height is reduced by ¼" when stacked.

You don't need support, by design.

I can print four at a time on my printer.