Desiccant Box
modernramp
Найти похожую с ИИ
Профиль печати(0)
Файл модели(0)
0
0
0
Опубликовано:2026-02-03 00:24:29
0
0
000Описание
Источник модели
Отзывы(0)
These are two part desiccant boxes with perforations on all six sides. There are 4"x4"x1" and 3"x3"x1" versions. When fitted together, the perforations on the four sides align for optimal air flow. Small tabs lock the pieces together, but do not prevent easy separation if required.
These were done in TinkerCad.
The 4x4x1 version: https://www.tinkercad.com/things/6ahNs0Nl9S6
The 3x3x1 version: https://www.tinkercad.com/things/0dQooKQkrfc
Print Settings
Printer:
Ender 3
Rafts:
No
No
Resolution:
0.2mm
20%
Filament: any PLA+ (aka PLA Pro) any
Notes:
The perforations are approximately 1.5 - 1.7 mm and should work well with silica beads whose minimum size is 2mm+. I used PLA+ because I feel it handles regeneration heat better than regular PLA. The boxes should be able to permit silica gel regeneration in either microwave or dehydrator.
I tested a box in a 60 - 70° C dehydrator for an hour. It did soften but did not lose retention integrity when handled. YMMVCare should be taken to avoid deforming a box when handling while in the softened state.
Category: 3D Printer AccessoriesИсточник модели
Оригинальная ссылка: Посмотреть детали
CC-BY