A collection of AD5X super waste chutes

This waste material chute is a tribute to the one on the FlashForge website. It is fixed to the waste material port using existing screws. It works whether there is a standard sealing design on the FlashForge website or not. It has a nice wide chute at a 60-degree angle, so it shouldn't clog up, because no one likes a "constipated" printer. The geometry is simple and can be printed without support. Just place the bottom of the slider on your print bed and print it. After printing, just remove the two screws on both sides of the

For me, I rotated the model by 45 degrees and set the direction of the solid fill to 0. I used the least amount of fill, mainly to ensure that there was something on the top layer to provide support.

Edit: December 16, 2025:Two variants of the material box and one variant with a chute that falls to the right have been added. There are two versions of the "right-facing" chute - with and without detachable supports. I will next make the material box for the "right-facing" version.

Edit: December 21, 2025:Here is the

The "left-facing" inclined chute directs the waste material to the left side of the printer

The model collection now includes:

• A "left-facing" inclined chute without a bracket

• A "left-facing" inclined chute with a stand

• A "right-facing" inclined chute without a bracket

• A "right-facing" inclined chute with a stand

• A 60-millimeter-long straight inclined chute

• A straight inclined chute 90 mm long

• A small condiment box

• A large storage box